PKCS#11 Configuration | Utimaco Integration Guides

Edit the cs_pkcs11_R2.cfg file located at “C:\ProgramData\Utimaco\PKCS11_R2” and make the appropriate changes to the file.

For more information regarding the commands and command parameters please check the Utimaco documentation. The device may be a CryptoServer (PCIe or LAN) device. The device line will follow one of these patterns, based on the HSM form-factor:

Device = 288@<HSM IP address> Hardware (LAN) HSM

Device = /dev/cs2.0 Hardware (PCIe) HSM

Example values

cs_pkcs11_R2.cfg

[Global]
# Path to the logfile (name of logfile is attached by the API)

# For unix:
#Logpath = /tmp

# For windows:
Logpath = C:/ProgramData/Utimaco/PKCS11_R2

# Loglevel (0 = NONE; 1 = ERROR; 2 = WARNING; 3 = INFO; 4 = TRACE)
Logging = 1

[CryptoServer]
# Device specifier
Device = 192.168.10.10

To make your testing easier, it would be good to enable the PKCS#11 log file. That can be enabled by editing the Logging Loglevel. Set the LogPath and Logging Loglevel to 1. For testing you may want to increase it to 4.

The added LogPath points to a writable directory, not to a file.

If you encounter problems, check the log file named cs_pkcs11_R2.log in the LogPath defined directory. When you are done testing, you should change Logging to 1 or 2. This will limit the logging to only critical and important messages.