Tested Versions
The integrations that have been successfully tested with the u.trust GP HSM with Cloudflare Keyless SSL.
|
Operating System |
Gokeyless |
Utimaco Security Server Version |
Utimaco HSM |
|---|---|---|---|
|
RHEL 9 |
1.18.0 |
SecurityServer V6.6.0 |
u.trust GP HSM CSe-Series/Se-Series |
List of tested versions
Cloudflare Keyless SSL requires the GoKeyless daemon to enable communication between Cloudflare edge nodes and the Utimaco HSM via PKCS#11. Direct integration without GoKeyless is not supported in this tested setup.
Software Requirements
|
Software |
Software Requirements |
|---|---|
|
Host VM |
Red Hat Enterprise Linux 9 or above |
|
GoKeyless |
GoKeyless daemon (v1.18.0 or compatible) |
|
Cloudflare Service |
Cloudflare Keyless SSL (active domain + account) |
|
HSM Software |
Utimaco SecurityServer (v6.6.0 or compatible) |
|
HSM Interface |
Utimaco PKCS#11 library (R3 module configured) |
|
Network Requirements |
Publicly reachable Keyless server (port 2407) |
|
Certificate Requirement |
Public CA-signed certificate (e.g., Let’s Encrypt, DigiCert) |
List of software requirements
Hardware Requirements
|
Hardware |
Hardware Requirements |
|---|---|
|
Utimaco LAN HSM |
u.trust GP HSM CSe-Series/Se-Series LAN with firmware SecurityServer 6.6.0 or higher |
|
Utimaco PCI-e HSM |
u.trust GP HSM CSe-Series/Se-Series PCI-e with firmware SecurityServer 6.6.0 or higher |
List of hardware requirements
Set up an account on the Utimaco support portal and request download access at the following URL: https://support.hsm.utimaco.com/ .
Prerequisites
Before you begin:
-
Ensure that the u.trust GP HSM is set up and configured. Ensure the HSM is initialized, reachable, and operational. Refer to the u.trust GP HSM documentation for setup instructions.
-
Ensure that the default administrative credentials are replaced. Replace the default admin user with a secure, custom admin user.
-
Ensure that the Master Backup Key (MBK) is generated and securely stored. The MBK must be created and stored across the HSM devices as per best practices.
-
Ensure that the Supported Operating System is installed. Ensure the host system is running a supported OS as listed in the Tested Versions section (e.g., RHEL 9 or above).
-
Ensure that the Utimaco SecurityServer is installed and configured. The SecurityServer version must match the tested version (e.g., v6.6.0), and the HSM should be accessible via the client tools.
-
Ensure that the PKCS#11 interface is configured and validated. The Utimaco PKCS#11 library (R3 module) must be installed and correctly configured. Verify access to the HSM using tools such as pkcs11-tool.
-
Ensure that the Cloudflare account with Keyless SSL is enabled.
-
Ensure the domain is onboarded to Cloudflare and the Keyless SSL feature is available/enabled in your account.
-
Ensure that the network connectivity and firewall rules are configured.
-
Ensure that port 2407 is open (default GoKeyless service port). Outbound/inbound connectivity between Cloudflare edge and GoKeyless server must be allowed.
-
Ensure there is root/administrative access to the host server. This is required for installing GoKeyless, configuring services, and managing certificates.