Tested Versions
|
Operating System |
Windows
|
Java |
JSign |
Utimaco SecurityServer Version |
Utimaco HSM |
|---|---|---|---|---|---|
|
Windows
|
10.0.28000.0 |
JDK 11.1 |
7.4 |
6.5.0 |
u.trust GP HSM Se-Series |
Tested versions
Supported Platforms
The integration was tested and validated on the platforms and software versions listed below. These platforms represent the environment used during integration testing of JSign with Utimaco u.trust HSM using the PKCS#11 interface.
Hardware and Software Requirements
|
Hardware |
Hardware Requirements |
|---|---|
|
Utimaco LAN HSM |
u.trust GP HSM Se-Series LAN with firmware SecurityServer 6.5.0 or higher |
|
Utimaco PCI-e HSM |
u.trust GP HSM Se-Series PCI-e with firmware SecurityServer 6.5.0 or higher |
List of hardware requirements
|
Software |
Software Requirements |
|---|---|
|
HSM Interface |
SecurityServer PKCS#11 Provider |
|
HSM Utility |
SecurityServer PKCS#11 Tool (p11tool2) |
|
JSign |
7.4 |
|
Java |
JDK 11.1 |
|
Windows SDK |
10.0.28000.0 |
List of software requirements
Prerequisites
Before proceeding, ensure you have:
-
Installed and configured the operating system listed in Tested Versions.
-
Installed and configured the SecurityServer version listed in Tested Versions.
-
Replaced the GP HSM Default Admin with a new admin user.
-
Created and stored the MBK onto each HSM. Refer to the u.trust HSM documentation to set up the MBK.
-
Set up and configured the GP HSM. Refer to the u.trust HSM documentation to set up the HSM.
-
Installed and configured Microsoft SDK as listed in Tested Versions.