The Utimaco Atalla Ax160 HSM is no longer in support. We provide a migration for security districts generated with Ax160 to AT1000. Contact OpenText Support for information.
If you are replacing or upgrading an Atalla HSM from version Ax160 to version AT1000, perform the following steps to make sure the new Atalla HSM contains the same MFK to support the existing districts:
-
Back up the MFK from the existing Ax160. Refer to the Atalla HSM and Atalla Secure Configuration Assistant-3 (SCA-3) documents for this operation.
-
Disable the Atalla HSM in the Management Console. Navigate to the System > Advanced page, deselect the Atalla HSM Enabled check box, and click Save Settings.
-
Restart the vsmgmt service and deploy.
-
Restore the MFK you backed up in Step 1 to the new or upgraded Atalla HSM. Refer to Atalla HSM and Atalla Secure Configuration Assistant-3 (SCA-3) documents for this operation.
-
If you are upgrading from Ax160 to AT1000, generate an AES MFK (AMK) on AT1000 prior to adding this HSM to the Appliance.
-
Add the new Atalla IP address to the Appliance.
-
Enable the Atalla HSM in the Management Console. Navigate to the System > Advanced page, select the Atalla HSM Enabled check box, and click Save Settings.
-
Restart the vsmgmt service and deploy.