If CXI module has not been installed on the SafeGuard CryptoServer, follow these steps to load the firmware module:
-
Start the CryptoServer Administration Tool (CAT) (Start → All Programs → Utimaco → SafeGuard CryptoServer).
-
Connect to your SafeGuard CryptoServer device.
In case of SafeGuard CryptoServer Se-Series, log in as user with administration privileges (e.g. ADMIN) as next.
-
Open the dialog Setup CryptoServer (Firmware Management → Setup CryptoServer).
-
Enter the license file if necessary, or leave it blank.
-
Select the firmware package file;
SecurityServer-2.60.2.mpk. -
Either chose UPDATE or NEW INSTALLATION as installation type. (Select UPDATE option if you want to update the existing firmware modules and keep your key databases unchanged, or select NEW INSTALLATION if you want to remove all key databases and firmware modules before upload of the new ones.).
-
To start uploading the firmware package, press SETUP.
-
You will be prompted to authorize the installation. Select either smartcard authorization or key file token authorization and press the OK button.
The SafeGuard CryptoServer will restart after the installation of the SecurityServer firmware package.
To check if your setup was successful, refer to the steps of chapter 3.4.1.